Mount Vernon Forklift Training Programs

Marysville Forklift Training Programs - If you are searching for a job as a forklift operator, our regulatory-compliant lift truck training programs provide exceptional instruction in numerous types and styles of lift trucks, lessons on pre-shift check, fuel kinds and dealing with fuels, and safe utilization of a lift truck. Practical, hands-on training assists participants in obtaining fundamental operational skills. Program content includes existing regulations governing the utilization of lift trucks. Our proven forklift courses are intended to provide training on these kinds of trucks: powered pallet truck, narrow isle forklift and counterbalanced forklift.

How to Safely Handle Loads

When the forklift is in use, do not raise or lower the forks. Loads should not extend higher than the backrest. This is because of the danger of the load sliding back towards the operator. Inspect for overhead obstructions and ensure there is enough clearance before raising a load. Stay away from overhead power lines. Once the load is lifted straight up, tilt it back slightly.

While the load is lifted the lift truck will be less stable. Make certain that no pedestrians cross beneath the elevated fork. The operator must never leave the forklift while the load is lifted.

The forks should be level when handling pallets, and high enough to extend all the way into and below the load. The width of the forks should provide even weight distribution.

Before unloading or loading the truck, chock the wheels and set the brakes. Floors need to be strong enough to support the weight of the load and the forklift combined. Fixed jacks can be installed to support a semi-trailer which is not coupled to a tractor. The height of the entrance door should clear the forklift height by a minimum of 5 cm. Mark edges of docks, rail cars or ramps and avoid them.

Do not stay inside a forklift for long periods without proper ventilation. The inside of the truck should be properly lighted and free of obstructions, trash and loose objects. Check for holes in the floor. The installation of material which are non-slip on the floor would help prevent slipping. Clear any obstructions from dockplates and docks and ensure surfaces are not oily or wet.

Forklifts must not be used to tow or push other forklifts.

Click to Download the pdf